Hey Guys, looking for a set of 16 full roller rockers. 3/8th" stud, non self aligning, has to clear centerbolt valve covers. Prefferibly 1.5 ratio, but if anyone is convinced a 1.6 ratio will work with a stroked motor I'd consider them too.

Thanks!

 

I have a set of Comp Cams Pro Magnum 1302-16 3/8 stud 1.6 ratio. Brand new. Briefly ran on motor but never driven. 200.00 + 3% paypal if interested.
http://www.compcams.com/information/.../ProMagnum.asp

 

Are you sure you need NON self aligning? I've got a new set of GMMP Bowties but they are self aligning.

 

thanks for the replies, yes my edelbrock heads have the guide plates...

zracer I'm checking out your rockers. Did you have centerbolt valve covers?

 

I didn't use the factory L98 valve covers I used the black composit LT4 corvette covers. Those motors came with roller rockers so the supports on the inside are smaller than your factory covers and don't require triming.

 

PM'd you...