WTB: Roller cam
Thread Starter
Junior Member
Joined: Nov 2010
Posts: 8
Likes: 0
From: Southern Alabama
Car: 87 Iroc Z? Figured that was obvious
Engine: 305 TPI
Transmission: 5 Speed
Axle/Gears: 3.08 9 bolt
WTB: Roller cam
Hey all looking for a roller cam for a 87+ block (305)
Heading towards a 230/236 @ .05 duration, used is fine with 30k or less miles. looking to spend around $100 on the cam, more if you have lifters and springs, maybe rods too, to go with it. let me know what you have please! going in a TPI motor so computer compatible is needed. brand isn't a such a big deal, but comp would be great. thank you in advance!
Change of plans : 112 lsa no more than 220/220 going to swing the torque curve down a hair bit let Me know what you might have
Heading towards a 230/236 @ .05 duration, used is fine with 30k or less miles. looking to spend around $100 on the cam, more if you have lifters and springs, maybe rods too, to go with it. let me know what you have please! going in a TPI motor so computer compatible is needed. brand isn't a such a big deal, but comp would be great. thank you in advance!
Change of plans : 112 lsa no more than 220/220 going to swing the torque curve down a hair bit let Me know what you might have
Last edited by 87_Iroc_Z; Jun 2, 2011 at 01:51 PM.
Thread Starter
Junior Member
Joined: Nov 2010
Posts: 8
Likes: 0
From: Southern Alabama
Car: 87 Iroc Z? Figured that was obvious
Engine: 305 TPI
Transmission: 5 Speed
Axle/Gears: 3.08 9 bolt
Re: WTB: Roller cam
bought a cam, see ashelia's engine rebuild thread for details
Thread
Thread Starter
Forum
Replies
Last Post