WTB - SBC hyd. roller - OE roller style
Thread Starter
Member
Joined: Nov 2010
Posts: 111
Likes: 0
From: Evansville IN
Car: 91 Z28
Engine: 350ci "fastburn 385"
Transmission: T56 / Quartermaster clutch
Axle/Gears: 9", 4.11, Auburn Posi
WTB - SBC hyd. roller - OE roller style
Hey all,
Looking for a hydraulic roller for SBC OE roller style block.
I actually have a '93 LT1 - but this cam is the same as the OE roller - I compared with another ZZ4 cam I had laying around. I guess it's the 95 and up that had that special LT1 cam with the long drive pin (for Opti drive).
So anyhow, looking to see if anyone has a GM hotcam, or the GM 846 or 847 cam, or comp cam, etc., in the 220/228 to 226/232 range, with lobe separation in 112 or 114 range for the factory LT1 fuel injection.
Needing to stay economical, say $150 or so. Lemme know what you got.
Cheers
Looking for a hydraulic roller for SBC OE roller style block.
I actually have a '93 LT1 - but this cam is the same as the OE roller - I compared with another ZZ4 cam I had laying around. I guess it's the 95 and up that had that special LT1 cam with the long drive pin (for Opti drive).
So anyhow, looking to see if anyone has a GM hotcam, or the GM 846 or 847 cam, or comp cam, etc., in the 220/228 to 226/232 range, with lobe separation in 112 or 114 range for the factory LT1 fuel injection.
Needing to stay economical, say $150 or so. Lemme know what you got.
Cheers