I need a factory trans crossmember, 1pc style. Would need to be shipped to 08848 NJ.

Thanks

 

I'll try and dig one out for a shipping quote today or tomorrow. Is a little rusty OK,.. or do I look for the 'best' one I can find ??

 

surface rust and grime is fine, I'd rather avoid any major rust or pitting.

Thanks!

 

Got 2:







The dirty one I got within the last year so it was easy to find; The clean one was cleaned up & stuffed away a few years back. Just so you know, this was harder to find; It was stashed about as far into the corner of my garage as it gets ! Both of them still have a used factory finish. Honestly; it shouldn't take too much 'elbow grease' to clean-up the dirty one.




I'd probably just wrap this thing a bunch of times then tape it up and ship it that way @ $14 'ground'. If you want it boxed it's gonna add a few inches, a pound or 2, and $3.

Send me a PM with your pic & an offer if your still interested,.............

 

Pm sent

 

John got me setup, this can be closed/locked