Question about LT1 heads
Thread Starter
Supreme Member
Joined: Aug 2001
Posts: 1,770
Likes: 1
From: Pacific Northwest
Car: '85 IROC
Engine: LB9
Transmission: 700 R4
Question about LT1 heads
I have a set of alum LT1 heads that I'd like to fit with a set of 2.0" and 1.55" valves. One shop told me it can't be done without new seats, but I could swear I've heard of it being done using the factory seats.
Anyone have any firsthand info on this?
Thanks for helping
Anyone have any firsthand info on this?
Thanks for helping
Supreme Member
Joined: Oct 2000
Posts: 3,819
Likes: 3
From: Angleton, TX
Car: '92 RS
Originally posted by Streetiron85
J's T/A
Thanks
I tried to google Lloyd Elliot and eportworks.com and couldn't find much, do you have a link by any chance?
J's T/A
Thanks
I tried to google Lloyd Elliot and eportworks.com and couldn't find much, do you have a link by any chance?
The best way to contact him is e-mail him at NightTrain66@msn.com. His website is www.eportworks.com, but he doesn't have much on there.
Senior Member
iTrader: (2)
Joined: Nov 2002
Posts: 774
Likes: 0
From: Idaho Falls
Car: 82 Trans Am
Engine: LTX
Transmission: T56
Axle/Gears: 3.42 strengthed 7.5 inch
He just started his website, but being that his prices are low (for now) and his workload high it is taking a while..
email and he will respond with boatloads of info.. good guy to work with.
email and he will respond with boatloads of info.. good guy to work with.
Thread
Thread Starter
Forum
Replies
Last Post