Ok to do this?????
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 66
Likes: 0
Ok to do this?????
i'm getting ready to take the motor out of my camaro. It's got a set of 210CC aluminum heads by AFR And a edelbrock victor JR Intake, my question is, can I lift the motor out with the heads and intake still on being that they are both aluminum?? I Dont want to end up cracking one of those heads since they were so freakin expensive......Whats the best way to go about this?? Thanks Guys
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: Ok to do this?????
Lots of people do, but something about them makes me nervous. I use an engine tilter with the chains bolted to the accessory holes in the heads.
Joined: Jan 2002
Posts: 3,449
Likes: 7
From: LONDON, KY
Car: Camaro
Engine: Carbed L98
Transmission: TH350
Axle/Gears: 3.73
Re: Ok to do this?????
I have some of the factory hooks that GM uses. The ones that are bolted to the stock heads. They works great.
