trashed the tbi put in LT1 which wires do i cut????
Thread Starter
Junior Member
Joined: Apr 2017
Posts: 2
Likes: 0
From: nevada
Car: 91 chevy ext cab 4" lift lt1 swap
Engine: 355
Transmission: 700r4
Axle/Gears: 3.73
trashed the tbi put in LT1 which wires do i cut????
- I did the SWAP ( 91 z71 w/700r4 no lockup, fuel pump elec. disconnected, the manual pump just sucks through the old pump in tank
-tossed in a ZZ4 motor, so sweet!!!!!!!! but..... the guy i bought it from left all the wiring in the orig. loom tapped up just sittin on the manifold.
What wires do i disconnect from the ecm so i can get the big bulky load of wires out of the engine bay and OUTA MY WAY!
Thanks a mil.!!!!!
-tossed in a ZZ4 motor, so sweet!!!!!!!! but..... the guy i bought it from left all the wiring in the orig. loom tapped up just sittin on the manifold.
What wires do i disconnect from the ecm so i can get the big bulky load of wires out of the engine bay and OUTA MY WAY!
Thanks a mil.!!!!!
Thread
Thread Starter
Forum
Replies
Last Post