A few years ago I knew a guy with an '86 Camaro. He had true duals with each pipe going over each axle dumping into flowmasters out back. He didn't mention how it was done, but I did look underneath the car. The rear suspension looked stock. There didn't seem to be any fabrication done.

My question is: Could air shocks allow enough room for the pipe to fit over the driver's side axle? I don't know if he had these kind of shocks. I didn't notice a rake on his car. I personally wouldn't want a huge rake, but I wouldn't mind a 1/2inch or so, if it could allow duals.

I don't see any other way he could've done true duals without any fab work. I've been reading this board for a while to see if anyone's ever done this; or if this is possible. Just thought I'd ask. :-)