manual cutouts??
Thread Starter
Junior Member
Joined: Mar 2004
Posts: 32
Likes: 0
From: Dallas, Texas
Car: 1989 Camaro RS
Engine: 305 TBI
Transmission: 700r4
manual cutouts??
does anyone know whre i can find cutouts that can open manually from a lever inside the car? i know mr.gasket or somone makes them that are like 2" but my piping is at least 2.5" i want cutouts but i dont want to have to crawl under my car everytime i want them open, thanx for the help
Member
Joined: Mar 2003
Posts: 356
Likes: 0
From: NE Ohio
Car: 1989 Toyota Supra Turbo
Engine: 7M-GTE
Transmission: R154
Axle/Gears: 3.91 LSD
Supreme Member
iTrader: (1)
Joined: Mar 2001
Posts: 4,226
Likes: 6
From: Chesterfield, Indiana
Car: 1991 Z28 Camaro
Engine: 5.7
Transmission: Jasper 700R4 Stage II
Axle/Gears: 3.23 For Now
i dont want to have to crawl under my car everytime i want them open
then why go with manual? Go with electric if you have the cash. The manual cutouts seem to leak really bad.....my McCord Power Plate doesn't leak at all....by the flip of a switch..it's NASACR loud....Flowmaster Loud....or anywhere in between...
Member
Joined: Feb 2003
Posts: 244
Likes: 0
From: Eastern Europe
Car: 98 T/A
Engine: ls1
there is even a group purchase on them going on roght now 
here's a link: http://www.mccordcg.com/mpp/tgogp.htm
right now they're $94
here's a link: http://www.mccordcg.com/mpp/tgogp.htm
right now they're $94
Thread
Thread Starter
Forum
Replies
Last Post
