Dynomax Question
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jun 2004
Posts: 1,663
Likes: 0
From: Menominee MI
Dynomax Question
hey guys i just wanted to make sure these are the right parts...
WLK-44063 is the intermediate pipe, that goes from the cat to the rearend...
WLK-43248 then that part is the axle hoop right, goes from the end of the intermediate pipe, over the axle, then into the muffler right??
These are out of summit
i think i'm gonna run a single 3" bullet muffler in the place of my cat, then use these pipes...do you guys know if dynomax makes a whole rear section too or would i have to get that made up, or does somebody else make one, like SLP or somebody??
WLK-44063 is the intermediate pipe, that goes from the cat to the rearend...
WLK-43248 then that part is the axle hoop right, goes from the end of the intermediate pipe, over the axle, then into the muffler right??
These are out of summit
i think i'm gonna run a single 3" bullet muffler in the place of my cat, then use these pipes...do you guys know if dynomax makes a whole rear section too or would i have to get that made up, or does somebody else make one, like SLP or somebody??
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jun 2004
Posts: 1,663
Likes: 0
From: Menominee MI
i saw they got this WLK-43244 and this WLK-43243 which are just the bends and the tips...i have my own 3.5" slashed tips so i feel 30 bucks a piece is wasting my money, should i just have a muffler shop or something bend up something that connects the tips to the axle hoop?
Thread
Thread Starter
Forum
Replies
Last Post
