Exhaust Post your questions and suggestions about stock or aftermarket exhaust setups. Third Gen exhaust sound files and videos!

Please help!

Thread Tools
 
Search this Thread
 
Old Jul 12, 2011 | 03:56 AM
  #1  
Thirdgen82's Avatar
Thread Starter
Junior Member
 
Joined: Dec 2010
Posts: 31
Likes: 0
From: Oxford, Alabama
Car: 1982 Camaro Z28
Engine: 350 small block
Please help!

I have a problem with my exhaust on my car, it is a round glass pack that is ran on the passenger side of the car all the way down and is cut off right under the rear floorboard. My exhaust has started dangling and scraping the road as i drive, i cannot find anywhere to clamp or tie the pip up to the car. i am afraid that the pipe will spark and catch fire or snag and break off....if anyone can help please do!
Reply
Old Jul 12, 2011 | 09:14 AM
  #2  
UnderCover89TBI's Avatar
Supreme Member
iTrader: (25)
 
Joined: Feb 2006
Posts: 7,260
Likes: 5
From: Manteca,California. Nor Cal.
Car: SOLD IT. Mopar guy only now.
Engine: gone
Transmission: gone
Axle/Gears: gone
Re: Please help!

You dont have an exhaust shop in oxford, alabama? if the exhaust was up before it can be up again. more than likely your exhaust hanger broke off and you need a new one welded on. that is what I would do. Take it to the exhaust shop.
Reply
Old Jul 12, 2011 | 01:30 PM
  #3  
1ADan's Avatar
Supreme Member
iTrader: (4)
 
Joined: Mar 2009
Posts: 3,079
Likes: 4
From: Pepperell, MA
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: Please help!

there were factory hangers at the cat and near the rear axle, but it sounds like your setup has been modified, so you may need to get another hanger installed to fix the issue.
Reply
Old Jul 12, 2011 | 08:52 PM
  #4  
Thirdgen82's Avatar
Thread Starter
Junior Member
 
Joined: Dec 2010
Posts: 31
Likes: 0
From: Oxford, Alabama
Car: 1982 Camaro Z28
Engine: 350 small block
Re: Please help!

The exhaust shop wanted $35 to put it up, can i just buy a hanger and get a welder friend to do it?
Reply
Old Jul 13, 2011 | 07:00 AM
  #5  
1ADan's Avatar
Supreme Member
iTrader: (4)
 
Joined: Mar 2009
Posts: 3,079
Likes: 4
From: Pepperell, MA
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: Please help!

go for it, if you've got a buddy who'll do it for free, can't pass it up
Reply
Old Jul 14, 2011 | 02:31 AM
  #6  
Thirdgen82's Avatar
Thread Starter
Junior Member
 
Joined: Dec 2010
Posts: 31
Likes: 0
From: Oxford, Alabama
Car: 1982 Camaro Z28
Engine: 350 small block
Re: Please help!

Where can i buy a exhaust hanger at?
Reply




All times are GMT -5. The time now is 11:07 PM.