I'm looking for various interior parts for the 88...
Hardtop pillar trims, both driver and rear passenger (don't know why the A-pillar trim is there on one side and not the other, but...).
Reasonable condition headliner, preferably black or charcoal and also seatbelt roof trims if available (may have the seatbelt trims already but need to look). Also decent condition sunvisors.
Black rear tail trim without t-tops and with hatch motor (can't get charcoal with the motor, so...).
Black hatch trim, covering the spoiler mount bolts and latch loop, with the cutout for the 3rd brake light/defogger wiring connector.

 

I can prob get a headliner board in good shape but u may wanna recover it, easy on a hardtop to do especially and cheap. Also i can pull pillars and prob roof trims and the hatch panel you need as well and im sure i have visors and the rear hatch motor cover panel. So basically everything mentioned. $325 shipped in USA.
Lmk if interested,
Thx
Ray

 

Owch! LMK if you find a black hatch panel (on the hatch itself) and/or visors. I think I might see what I can find at the junkyard when I go to negotiate the 93-97 Camaro dash I want to put in the Z. I already know there isn't any black parts that are any good there. Worse comes to worse, I'll just put the carmine back in (but still be without one visor, headliner, pillar trims, carpet, or matching seats).

 

Gonna PM ya ! Well get it done.
Thx
Ray

 

Giving this a bump...

Found out I also need the metal rods that run between the door lock motors and the intermediate levers/bellcranks on both doors. These attach to the end of the motor shaft and run up to the lever that pushes/pulls on the interior lock lever rod that runs from the latch to the door lock indicator handle under the inner door handle... I mostly need the one for the passenger's side door (I have the driver's side rod but the other is AWOL), but I'll take both.

 

i have a complete t top interior in black, less the dash pad and carpet- ill check to see if i have the rear panel-im only about an hour or so from you

 

andy, I might take you up on that... Too bad I'm getting rid of the t-top as I could've used a headliner for it .

Don't need the door lock parts... I found the other lock rod today and put it in before it went AWOL again . But, I looked closely at the seatbelt assemblies (the black ones I have) and I need the trim piece that goes against the headliner that the belt passes through on the passenger's side.