4th Gen Carpet question
4th Gen Carpet question
Hey guys, sorry if this has been asked before I have searched and searched and couldn't find information relating specifically to this, But lots of great info on other 4th gen projects. Will 4th Gen carpet fit into my 87 Z28? Only reason I ask is it will be alot easier for me to find 4th crapet in good condition at a bonyard than the 3rd gen. Has anyone successfully done this, or can it be done. Thanks for any input.
Joined: Dec 2000
Posts: 2,361
Likes: 2
From: Buffalo, NY
Car: 1984 Trans Am
Engine: LT1
Transmission: T56
Axle/Gears: 10 bolt w/ 4.10 gears
Re: 4th Gen Carpet question
there are some "yes" and some "no" answers in that thread. I can tell you from personal experience that they swap over VERY well! The only differences I found were that I had to cut different holes for the front seatbelt receiver (the 4th gen holes lined up too low) and the passenger side cat hump/dip isn't quite the same... the dip is lower on the 3rd gens so there is a bit of space under the dip in the carpet. hardly noticable though. The 4th gen also had basically 1 section of carpet that went all the way to the storage well in the trunk, but can be cut under the seats as the 3rd gen is. I don't know how anyone could say it doesn't swap with such minor differences
Thread
Thread Starter
Forum
Replies
Last Post





