My whole front panel gauges went out and the only one that works is the rpm
Thread Starter
Junior Member
Joined: Oct 2009
Posts: 61
Likes: 0
My whole front panel gauges went out and the only one that works is the rpm
The only one gauge that works just spins no control as soon as i hit the accelerator? should i pick up a whole new one or take this one apart?
Senior Member
iTrader: (4)
Joined: Mar 2006
Posts: 683
Likes: 2
From: Florida
Car: '87 Trans-Am
Engine: LB9 (305 TPI)
Transmission: 700R4
Axle/Gears: 3.42 or 3.73..figuring it out still
Re: My whole front panel gauges went out and the only one that works is the rpm
It's probably connections behind the dash...try and get back there and see what you have going on. remove the Instrument panel and look at the wiring/connections where everything plugs in...could be corroded like mine was. If it is, remove the cluster and lightly clean the contacts with contact oil and a used scotch brite pad or something and try and reinstall it and see what you get.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
