[Wanted] LSx parts
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jan 2012
Location: Clark NJ
Posts: 877
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1988 Pontiac Transam GTA Notchback
Engine: 2003 Chevy 5.3 Vortec (325 cu)
Transmission: 4L60E
Axle/Gears: 3.27
LSx parts
Hi, I figured this would be a good time to start this. I have gotten several parts for my engine swap and now I am looking for f-body accessories from a 4th gen bird or camaro. This swap is extremely budget oriented.
Also for the block I am open to 5.3, 5.7 or 6.0. It is not a swap for power (can always upgrade later) It is more reliability, gas mileage (my current 12 is unacceptable), and efficiency.
So far I have:
-wiring
-fuel tank pending
-driveshaft pending
-LS1 intake pending
Big stuff I need:
-block (without it whats the point)
-accessories
-heads
-4L60E - another big one
Also for the block I am open to 5.3, 5.7 or 6.0. It is not a swap for power (can always upgrade later) It is more reliability, gas mileage (my current 12 is unacceptable), and efficiency.
So far I have:
-wiring
-fuel tank pending
-driveshaft pending
-LS1 intake pending
Big stuff I need:
-block (without it whats the point)
-accessories
-heads
-4L60E - another big one
#2
Senior Member
iTrader: (1)
Join Date: Dec 2003
Location: Ravenna, Ohio
Posts: 703
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Trans Am GTA
Engine: 408 LS
Transmission: LS 4L60E
Axle/Gears: 9 Bolt/3.70 Gears/TAP Girdle
Re: LSx parts
I have some 317 6.0 heads for sale. They are complete except for rockers.
#4
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jan 2012
Location: Clark NJ
Posts: 877
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1988 Pontiac Transam GTA Notchback
Engine: 2003 Chevy 5.3 Vortec (325 cu)
Transmission: 4L60E
Axle/Gears: 3.27
Re: LSx parts
So Update:
Have:
-harness
-intake
-driveshaft
-k-member with a notch
Need:
-tank
-block
-heads
-accessories
-tranny
As for the heads, I am going to try to find a block before I find heads (maybe I will find a block with heads)
I will probably send an email to the guy on Craiglist, thanks Punkmaster
Block is on the top of the list, open to 5.3, 5.7 or 6.0, depending on which is cheaper+low miles (yea I know-- Needle in the haystack, but I have patience, and unless my B2C craps out tomorrow, I can wait a bit. )
Have:
-harness
-intake
-driveshaft
-k-member with a notch
Need:
-tank
-block
-heads
-accessories
-tranny
As for the heads, I am going to try to find a block before I find heads (maybe I will find a block with heads)
I will probably send an email to the guy on Craiglist, thanks Punkmaster
Block is on the top of the list, open to 5.3, 5.7 or 6.0, depending on which is cheaper+low miles (yea I know-- Needle in the haystack, but I have patience, and unless my B2C craps out tomorrow, I can wait a bit. )
#6
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jan 2012
Location: Clark NJ
Posts: 877
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1988 Pontiac Transam GTA Notchback
Engine: 2003 Chevy 5.3 Vortec (325 cu)
Transmission: 4L60E
Axle/Gears: 3.27
Re: LSx parts
I now need a transmission (4L60E)
a 4L60E conversion crossmember for 3rd gens
LS1 clamshells
new fuel pump
Grand Prix 0-90 ohm conversion for LS1 sending unit
corvette regulator/filter
a 4L60E conversion crossmember for 3rd gens
LS1 clamshells
new fuel pump
Grand Prix 0-90 ohm conversion for LS1 sending unit
corvette regulator/filter
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
11-14-2015 12:02 AM