I'm posting this here as well as in teh DIY ECM section, hoping that someone has solved this.
I already have my LT1 in my '89 TA. works great with tunercat.
I want a little more control and visibility as to what the motor is doing. Megasquirt was the cheapest and in my case the best choice.

Trying to figure out if there is a 36-1 toothed wheel that someone has found to fit the crank pulley without too much modification. I want to run EDIS (already have the parts) so that i can go distributorless. I'm figuring on using LS1 coils.
Can anyone point me in teh right direction? I found a great article on it from a guy who put an LT1 into an S10, but the article fell short of the actual wheel used.

Thanks.