Anyone DIY an e38 ecm standalone harness yet?
Thread Starter
Supreme Member
Joined: Sep 2003
Posts: 1,408
Likes: 2
From: Western Maryland
Car: 82z28
Engine: 406
Transmission: th350
Axle/Gears: 3.23
Anyone DIY an e38 ecm standalone harness yet?
I've got a 2007 lh6 im looking to put in front of a th350.
I have completed the depinning listed on lt1swap.com, and have a few questions.
1. Are there any shared connections among the transmission harness or tcm wires I need to retain for any reason?
2. Are there any tricks to obtaining a working obd2 port when removing the lions share of the harness? Is it only connecting power, grounds and the remainder of the CAN wires?
I have completed the depinning listed on lt1swap.com, and have a few questions.
1. Are there any shared connections among the transmission harness or tcm wires I need to retain for any reason?
2. Are there any tricks to obtaining a working obd2 port when removing the lions share of the harness? Is it only connecting power, grounds and the remainder of the CAN wires?
Joined: Sep 2010
Posts: 1,626
Likes: 46
From: Double Bratville
Car: '89 Formula
Engine: LS2
Transmission: 4L65E
Axle/Gears: MW 3.42 12 Bolt
Re: Anyone DIY an e38 ecm standalone harness yet?
EFI Connection is in PA. Might be close enough to you to be of assistance.