What do i need
Thread Starter
Senior Member
Joined: Apr 2008
Posts: 368
Likes: 0
From: O'Neill NE
Car: 83 Z28 Camaro
Engine: 305
Transmission: 5 Speed manual
Axle/Gears: 3.73
What do i need
im going to buy this wheels when i get the money or them after my second half of my hid upgrade.
http://www.wheelreplicas.com/z06_moto.html
i have a few questions
1. whats the difference between motosport and regualar zo6 wheels?
2. its shows the offset and backspacing... but were do i buy those? or will they come with them? and what will those make it look like on a stock rear end?
3. and is 17 by 9.5 too much on the front for turning and such?
http://www.wheelreplicas.com/z06_moto.html
i have a few questions
1. whats the difference between motosport and regualar zo6 wheels?
2. its shows the offset and backspacing... but were do i buy those? or will they come with them? and what will those make it look like on a stock rear end?
3. and is 17 by 9.5 too much on the front for turning and such?
Former Sponsor
Joined: Mar 2009
Posts: 3,726
Likes: 4
From: Westford, MA
Re: What do i need
HI,the wheel replica wheels are nice.I'd give them a call since they manufacture the wheels and let them know of your concerns and questions,I'm sure they'd be happy to help you out.
T
T
Member
iTrader: (1)
Joined: May 2003
Posts: 457
Likes: 1
From: NC
Car: '91 Camaro Z28
Engine: 383 Vortec HSR
Transmission: Pro-Built 700-R4;Vig 4000 stall
Axle/Gears: Moser M9 9" / 3.89
Re: What do i need
I know the motosport ones have the rivets all over the edge of the rim, where as the Z06 OEM wheels did not. Not sure about the offset/backspace, and for the third question I've heard people say 9.5 is ok, but it will depend of the backspacing/offset. I'd do a search on here about the backspacing.