wtb chevy heads
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
hmmm....think i have 461 or 462s in the garage....i'll check for you.
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
462624 is the casting on them
they are stripped down bare since i was going to redo them. Already hot tanked once to clean them up. I have all valves and retainers although you would probably run new retainers anyways, springs were thrown out. They're 1.94/1.50 valves although i assume you could have the heads cut for the bigger valves. Came out of an early 70s vette motor was tired when pulled but still ran ok.
$50 to just get rid of them.
they are stripped down bare since i was going to redo them. Already hot tanked once to clean them up. I have all valves and retainers although you would probably run new retainers anyways, springs were thrown out. They're 1.94/1.50 valves although i assume you could have the heads cut for the bigger valves. Came out of an early 70s vette motor was tired when pulled but still ran ok.
$50 to just get rid of them.
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Sponsored Vendors
0
Aug 26, 2015 02:18 PM
NinjaNife
Tech / General Engine
27
Aug 23, 2015 11:49 AM
TA8487
Engine/Drivetrain/Suspension Wanted
1
Aug 16, 2015 12:21 PM
Mister_Johnny99
Interior Parts Wanted
0
Aug 14, 2015 12:59 PM