Welding SBCs in Northeast Ohio?
Thread Starter
Senior Member
iTrader: (2)
Joined: Feb 2006
Posts: 619
Likes: 0
From: Wilmington,NC
Car: 87 trans am
Engine: 305
Transmission: T5
Axle/Gears: 3.42 SLP rear
Welding SBCs in Northeast Ohio?
I'm looking into getting a set of Subframe connestors and I want to get them welded in really well. Is there anyone in Northeast Ohio I should look up?
Didn't get a set yet, probably gonna get the Spohn set...
Any thoughts?
Didn't get a set yet, probably gonna get the Spohn set...
Any thoughts?
Senior Member
iTrader: (1)
Joined: Dec 2003
Posts: 703
Likes: 0
From: Ravenna, Ohio
Car: 87 Trans Am GTA
Engine: 408 LS
Transmission: LS 4L60E
Axle/Gears: 9 Bolt/3.70 Gears/TAP Girdle
nobody i can really recommend, just make sure they are welded on with the wheels and suspension under load.
Thread Starter
Senior Member
iTrader: (2)
Joined: Feb 2006
Posts: 619
Likes: 0
From: Wilmington,NC
Car: 87 trans am
Engine: 305
Transmission: T5
Axle/Gears: 3.42 SLP rear
Wow, alot closer than I thought I'd get an answer from. If I can get a friend to help, would it work if we put the whole car on drive on ramps?
Senior Member
iTrader: (1)
Joined: Dec 2003
Posts: 703
Likes: 0
From: Ravenna, Ohio
Car: 87 Trans Am GTA
Engine: 408 LS
Transmission: LS 4L60E
Axle/Gears: 9 Bolt/3.70 Gears/TAP Girdle
yes that would work, all 4 tires on ramps would keep the suspension under load. Just make sure all 4 ramps are the same height. I'm just down here in ravenna, I go up to burton all the time. My gf has family there, just off 44 by little punderson.
Thread
Thread Starter
Forum
Replies
Last Post
no green
Engine/Drivetrain/Suspension Parts for Sale
11
Jan 9, 2016 09:22 PM