Estimates on time
#1
Estimates on time
Hello everyone! I'm new to this forum but I feel like I will be coming here quite often! My father and I recently purchased an 86 Iroc-Z to build into a drag car. Project has been going well, but I am really curious as to what I should expect as far as ET goes. I don't think it will be ready until about December but until then I will ask.
The setup is looking like this
Interior completely stripped w/ 12 point rollcage
Stock 7.5" rear-end with 4.10 gears
TH-350 transmission
350 bored 60 over
Holley 750 DP
World S/R Torquer heads
Crane Roller rockers
Comp Xtreme Energy cam - 256/268 , .449''/.456'' (99% sure this is the cam specs, cant fully remember but lets go with these)
Dish pistons
Weiand Team G intake
MSD 6AL-2 ignition
All being stuck to the road by 28.5x8.0 slicks
Oh and obviously straight headers
I realize this may or may not be too much information, but that's okay.
The setup is looking like this
Interior completely stripped w/ 12 point rollcage
Stock 7.5" rear-end with 4.10 gears
TH-350 transmission
350 bored 60 over
Holley 750 DP
World S/R Torquer heads
Crane Roller rockers
Comp Xtreme Energy cam - 256/268 , .449''/.456'' (99% sure this is the cam specs, cant fully remember but lets go with these)
Dish pistons
Weiand Team G intake
MSD 6AL-2 ignition
All being stuck to the road by 28.5x8.0 slicks
Oh and obviously straight headers
I realize this may or may not be too much information, but that's okay.
Last edited by TexasMaro; 09-15-2015 at 06:35 PM.
#2
Moderator
Join Date: Jul 1999
Location: 51°N 114°W, 3500'
Posts: 17,110
Likes: 0
Received 120 Likes
on
101 Posts
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Re: Estimates on time
I don't see anything special. Should be able to get into the 12's.
Give me some dyno numbers and a race weight and I can give a much better guess.
Give me some dyno numbers and a race weight and I can give a much better guess.
Thread
Thread Starter
Forum
Replies
Last Post