Guys, the body shop I took the car to is ****ing me over... I need to find a new shop that will either do it right or won't do it! Any suggestions? I would mind dragging the car to Oregon if I have to...
Basically what happened is that I went and looked at the car, and they said the frame was straight, though it was totally obvious the frame was not... the rear sits low, still. We looked at Jesse's car, and it lines up nicely, while mine is not even close... ARG!!!
Thanks,
Douglas

 

Well man, If I were you, Id pick up the yellow pages, and call each shop in the area. Tell them whats up, Go and check out the ones that impress you the most.

Driving it to Oregon is a waste of time and money IMO, and Im sure there are some damn good shops in Seattle.

Hope that helps man. Good luck.

-Roshambo

------------------
-Joe
1988 Pontiac Trans Am WS6 - 305 TPI, 700R4, 3.23 Posi, Digital Dash, Leather Seats, Maui Blue with Silver GFX, T-tops, Tinted Glass, Gutted MAF, TB Coolant Bypass, K&N Cone Filter, No Cat, 3" exhaust from Y-pipe back, MSD Super Coil, Accel 8mm wires, L98 Aluminum Heads, Ported and Polished Plenum, Siamesed Intake, Aluminum Driveshaft, Edelbrock 3 point Strut Tower Brace

 

if it helps, we have a place here in salt lake called the paint spot. They will pull and straighten frames, and they do damn good work. Maybe you have a place like that in seattle?

 

I'll get some phone #'s for you on wednesday... theres atleast 2 in monroe that will give you a damn good price and I can talk to my moms crackhead boyfriend (AKA my current employer) to see if I can get him to get me his friends phone # (Friend owns body shop, owes terry LOTS of favor's)