WTB T5 tranny for V8 must work
Thread Starter
Member
Joined: Jul 2001
Posts: 187
Likes: 0
From: Keyport, WA
Car: 98 Z28
Engine: 346 LS1
Transmission: 6 spd.
Axle/Gears: Ford 9" 4.11
WTB T5 tranny for V8 must work
Looking for a working T5 tranny for a V8 car. Would prefer to have a World Class, but may settle for a NWC if it's in good working order and the price is right. Thanks in advance. PM if you've got anything.
Sean
Sean
Junior Member
iTrader: (6)
Joined: Apr 2003
Posts: 51
Likes: 0
From: North Carolina
Car: 86,86,89, all IROC-Zs
Engine: 305cccarb,3sumtin,305 tpi
Transmission: 700R4s
Axle/Gears: 2:73open,3:42posi,2:73posi
i have an 84 in good condition. what would you put into this one. the gears are in good condition. syncronizers look like they are new. this was part of a deal for a parts car.
Last edited by mksp89IROCZ; Apr 30, 2006 at 09:32 AM.
Member
iTrader: (2)
Joined: May 2003
Posts: 362
Likes: 1
From: bakersfield, ca
Car: 92 B4C/1LE CHP camaro 06 vette LS2,
Transmission: iroc, 700r4, auto
i've got a 91 WC T-5 complete and in excellent condition for 900.00 email ron09517@aol.com
Thread Starter
Member
Joined: Jul 2001
Posts: 187
Likes: 0
From: Keyport, WA
Car: 98 Z28
Engine: 346 LS1
Transmission: 6 spd.
Axle/Gears: Ford 9" 4.11
Thanks for the replies. I don't want to put a lot of money into a NWC but for a good price I would probably buy one. How much are you looking to get out of the '84 tranny?
900.00 is a little to much for me to pay for a WC, I can have a super alloy gear kit and a complete rebuild done to mine for less than that. Thanks for the reply though.
Sean
900.00 is a little to much for me to pay for a WC, I can have a super alloy gear kit and a complete rebuild done to mine for less than that. Thanks for the reply though.
Sean
Member
iTrader: (2)
Joined: May 2003
Posts: 362
Likes: 1
From: bakersfield, ca
Car: 92 B4C/1LE CHP camaro 06 vette LS2,
Transmission: iroc, 700r4, auto
guess i should have been a little more clear. the 900.00 is for the complete 5 speed changeover. trans, bell housing, clutch, flywheel, pedals, master and slave cylinders, shifter.....everything needed to go from auto to manual.
Thread Starter
Member
Joined: Jul 2001
Posts: 187
Likes: 0
From: Keyport, WA
Car: 98 Z28
Engine: 346 LS1
Transmission: 6 spd.
Axle/Gears: Ford 9" 4.11
Sorry about the misunderstanding. My car is already a manual, in fact I just bought new slave, master, clutch, flywheel, TOB and pilot bearing about a month ago, then my tranny went out, so all I'm looking for is a tranny.