Before I call ATI in the morning I was hoping to find out if any of you have run into similiar problems. I'm at the end of installing an ATI P1-SC blower into my 91 Z28. I have the blower bracket mounted correctly but the damn blower actually hits the fender well before it rotates into place. I'd show pics but my dig camera is at work right now. I need the blower to rotate clockwise another 10-15 degrees before the other mounting bolt bites. Anyone have similiar fit problems?

 

My blower hit the Fuel lines, after I bent them a little it fit. But this was a P600B on a trans am......

 

The back half of the blower housing which the outlet is on, rotates in relation to the front half. Just loosen all the small hex head bolts around the perimeter and rotate it until the outlet points where you want it to.