Was wondering what i would be running with this set up just pretend that all the little stuff would hold up like the connecting rods and crankshaft etc..........

1.350 TPI rebuilt with superram intake
2.Pro charger supercharger at 11 psi with intercooler
3.edelbrock centerbolt heades aluminum ported and polished
4.Crane cam rpm power 3000-6000rpm
5.Bored out .30
6.T56 6 speed manual trans
7. 4.11 ring and pinnion
8. 9inch ford rear end
9. carbon fiber drive shaft
10. 1 3/4 slp headers
11. dual 2 1/2 exhaust system with X pipe
12. All the interior taken out just pedals and shifter and seat in car all other stuff out.
13. Leight weight glass
14.Fiberglass(fenders,doors,hood,front and rear bumper cover,hatch.
15.Spohn (subframe connectors,torque arm,panhard rod,rear control arms)K member,tubular front a arm, lowerd 2 inches.


thats my dream set up just wondering what i should be running when i get all that stuff(if i ever)i hoping for med 11's
:lala: :lala: :lala: :lala: :lala: :lala:

what will it run you ask...? FAST...

If you had to guess at a 1/4 mile time.

I dont think you can launch full boost on a centrifugal without the load of a trans or foot brake on an auto. so with the stick full boost out of the hole might not be possible.

That is just pretty much impossible to do

how about at 9