Why me?
Thread Starter
Joined: Dec 1999
Posts: 5,964
Likes: 37
From: Hacienda Heights, CA
Car: 90 RS 'Vert, 88 IROC-Z, 88 Firebird
Engine: 305 ci tbi, 305 ci tpi, 350 ci tpi
Transmission: WC-T5, WC-T5, 700R4
Axle/Gears: 3.45, 3.27, 3.27
Why me?
I drove my Dodge truck down to El Cajon yesterday to pick up an item for the shop I'd won on eBay. Yahoo maps works great, I got to the address and discovered it was at the end of a cul-de-sac. The driveway was a steep narrow one curving up to the house. I decided there was no way I'd try to drive my long truck up there. So I proceed to back up to park near the curb. CRUNCH! I'll pause here to remind everyone it has been exactly one week since I had my truck body repaired.
Back to the story: I pull forward and spot the problem. A pole. WTF??
I'm a full 3 feet from the curb! I get out and see a portable basketball board with a heavy plastic base holding this nice pole for me to hit. Roughly 2 feet in front of my last damage is a nice dent in the rear door where the side molding and the metal behind it is pushed in. I also see 3 small dents in the lower front door. Last time was $800+ of which I paid $500. I'm not looking forward to what this will cost. I guess I just can't catch a break.
Lon
Back to the story: I pull forward and spot the problem. A pole. WTF??
I'm a full 3 feet from the curb! I get out and see a portable basketball board with a heavy plastic base holding this nice pole for me to hit. Roughly 2 feet in front of my last damage is a nice dent in the rear door where the side molding and the metal behind it is pushed in. I also see 3 small dents in the lower front door. Last time was $800+ of which I paid $500. I'm not looking forward to what this will cost. I guess I just can't catch a break. Lon
Supreme Member
iTrader: (3)
Joined: Feb 2002
Posts: 2,635
Likes: 1
From: Central Coast Calif.
Car: 91' Camaro
Engine: 383 ci
Transmission: T-56
Axle/Gears: 9 bolt / 3:70
Bummer to hear that....
Good luck with getting by on the cheap, I know how much just paint costs, let alone damage.
Good luck with getting by on the cheap, I know how much just paint costs, let alone damage. Thread Starter
Joined: Dec 1999
Posts: 5,964
Likes: 37
From: Hacienda Heights, CA
Car: 90 RS 'Vert, 88 IROC-Z, 88 Firebird
Engine: 305 ci tbi, 305 ci tpi, 350 ci tpi
Transmission: WC-T5, WC-T5, 700R4
Axle/Gears: 3.45, 3.27, 3.27
Not a chance. It is in an area where there is a heavy formed section in the steel panel. It also flaked off a big chunk of paint, roughly 1" wide. They will have to get into the door to repair it. Unless they can spot-weld on studs and pull it out. I'll let the experts tell me how and how much. Thanks for the thought though.
Lon
Lon




