parting tpi set up (speed density), lb9, dual fans
Thread Starter
Joined: Apr 2006
Posts: 1,024
Likes: 7
From: Santa Ana, CA
Car: 90 IROC-Z
Engine: Lsa
Transmission: M6
Axle/Gears: 9" spooled 3.70
parting tpi set up (speed density), lb9, dual fans
like the title says off 90 camaro i have; ecm (305 at), wiring harness, base, fuel rails, injectors(19lb), runners (started to polish right one), plenum, throttle body, all sensors although not sure of condition of them. All I can think of that is missing is hardware and iac valve. Everything is dirty but this would be great for someone wanting a spare set to polish, or if you want i have the lb9 to go with(needs rebuild) $275 for everything on the top end and $400 with motor(includes serp setup) and everything. Also selling dual fans with mounting brackets $90
give me a call if interested 714 884 9320 leave a message
give me a call if interested 714 884 9320 leave a message
Senior Member
iTrader: (5)
Joined: May 2007
Posts: 612
Likes: 0
From: Lynwood
Car: 91 RS Vert/98 Sierra9
Engine: 5.7/5.0
Transmission: 5spd/auto
Axle/Gears: 4th gen rear with 3.73
Re: parting tpi set up (speed density), lb9, dual fans
Would you be willingto sell the mounting brackets for dual fans?
Thread Starter
Joined: Apr 2006
Posts: 1,024
Likes: 7
From: Santa Ana, CA
Car: 90 IROC-Z
Engine: Lsa
Transmission: M6
Axle/Gears: 9" spooled 3.70
Re: parting tpi set up (speed density), lb9, dual fans
bump make an offer need to pay rent
Thread
Thread Starter
Forum
Replies
Last Post