Has anyone attempted to install a C4 corvette rear suspension in a 3 gen f-body? What was involved, what problems?
I remember reading an interview with John Heinrichey were he stated that they had done several conversions on prototypes and had it ready to be a bolt in conversion but was canceled because at that time they thought the 4th gen would have independent suspension.

 

I know it's been done, but it's a totally custom deal, not even close to being bolt-in. It would require a whole lot of custom fabrication and a good welder at the least. The total expense of that would just about make it cheaper to just buy a whole Corvette to drive unless you can do the engineering, fabricating, and welding yourself.

 

There are quite a few guys doing it, check this out for more details:
http://www.rareautodesign.com/