what is a cheap way to get rear disc brakes. how hard is it to do?

 

When I did my 9" swap I went with a set of aftermarket units from a company called TSM. The kit uses an 11" rotor. I'm pretty sure they make a kit for drum braked thirdgen rears. They will sell just the brackets if you want or a whole kit. Calipers with emergency brake provisions are available. Total cost for the kit I have was less than $300.

TSM, 9635 Hwy. 85, #8, Littleton, CO 80125, 303/688-6882


[This message has been edited by Dan W (edited April 25, 2001).]

 

do they have a website? i can't find one. thanks for the reply, anyone else?

 

They used to have a small page but I think its gone. They advertise in one of the street rod mags.