Wonderbar question
Thread Starter
Member
Joined: Nov 2013
Posts: 112
Likes: 0
Car: 85 Trans Am
Engine: 5.7TPI
Transmission: 700R4
Wonderbar question
Hi I was just wondering if anyone has any dimensions of a wonderbar for my 85 trans am? I am a metal fabricator and tig welder and have lots of 1.25 chrome molly tubing available and would like to fab my own up. Also if anyone has other blueprints etc to custom build own parts for steering and suspension stability and stiffening would be fantastic!!!
Thanks so much!
Brad
Thanks so much!
Brad
Joined: Sep 2005
Posts: 27,881
Likes: 2,434
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Wonderbar question
That's WAY too big.
A stock one is less than ¾". Might only be ½".
No need putting a piece of railroad track weight right on the nose of the car.
Go out and look at your car; all you need is 2 plates to bolt under your front sway bar bushings, and a tube to couple them together. For sure wouldn't have to be any bigger than ½" OD if it was chrome-moly.
A stock one is less than ¾". Might only be ½".
No need putting a piece of railroad track weight right on the nose of the car.
Go out and look at your car; all you need is 2 plates to bolt under your front sway bar bushings, and a tube to couple them together. For sure wouldn't have to be any bigger than ½" OD if it was chrome-moly.
Supreme Member
Joined: Apr 2006
Posts: 4,482
Likes: 9
From: Northern, CA
Car: 1989 Iroc-Z Camaro
Engine: TBI,5.0
Transmission: Automatic 700R4
Axle/Gears: Eaton Posi,3.42,LPW Ultimate Cover
Re: Wonderbar question
Last edited by Ron U.S.M.C.; Dec 10, 2013 at 05:30 AM.
Thread
Thread Starter
Forum
Replies
Last Post