Lubricating ball joints
03-31-2014, 11:23 AM
#1
Junior Member
Thread Starter
Join Date: Jan 2007
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Lubricating ball joints
I installed new moog ball joints which have a port for grease to come out when full. I pumped it up pretty good but don't see any grease coming out of the port. I can't really see the port either, I think it's in the folds of the rubber cover. I sure don't want to screw anything up. Any advice?
03-31-2014, 06:43 PM
#2
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,651
Likes: 0
Received 46 Likes
on
44 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Lubricating ball joints
Keep pumping til u see the rubber start to expand. Usuallly keep going till some pushes out around the end of the boot. You would be surprised how much greare a dry balljoint will hold.
04-02-2014, 09:42 PM
#3
Junior Member
Thread Starter
Join Date: Jan 2007
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
sjorgens
Suspension and Chassis
7
10-01-2015 07:54 PM