No LS1
Thread Starter
Member
Joined: Jan 2004
Posts: 107
Likes: 0
From: Houston TX
Car: 91 firebird TBI
Engine: Three SLow Five. LO3
Transmission: MAN 5 SPD B0RG WARNER, 77MM, 2.95
No LS1
After careful consideration, i decided that i would just build up my 305 for now and somewhere down the line i will swap the LS1 in there.
Until then, i am looking to make as much power as possible out of that LO3.
A helpful person advised me to use these in my setup:
Vortec Heads
Lt1 cam or Comp Cam
new timing piece
headers and exhaust
msd 6al
edelbrock performer rpm intake
Would that be good. About how much power would that make?
Until then, i am looking to make as much power as possible out of that LO3.
A helpful person advised me to use these in my setup:
Vortec Heads
Lt1 cam or Comp Cam
new timing piece
headers and exhaust
msd 6al
edelbrock performer rpm intake
Would that be good. About how much power would that make?
Supreme Member
Joined: May 2003
Posts: 1,995
Likes: 0
From: Toledo, OH
Car: 1992 Firebird
Engine: forged 357
Transmission: 700r4, 2200-2400 stall, vette servo
Axle/Gears: stock pegleg 2.73 drum (temp)
Re: No LS1
Originally posted by dopplereffect
After careful consideration, i decided that i would just build up my 305 for now and somewhere down the line i will swap the LS1 in there.
Until then, i am looking to make as much power as possible out of that LO3.
A helpful person advised me to use these in my setup:
Vortec Heads
Lt1 cam or Comp Cam
new timing piece
headers and exhaust
msd 6al
edelbrock performer rpm intake
Would that be good. About how much power would that make?
After careful consideration, i decided that i would just build up my 305 for now and somewhere down the line i will swap the LS1 in there.
Until then, i am looking to make as much power as possible out of that LO3.
A helpful person advised me to use these in my setup:
Vortec Heads
Lt1 cam or Comp Cam
new timing piece
headers and exhaust
msd 6al
edelbrock performer rpm intake
Would that be good. About how much power would that make?
Thread Starter
Member
Joined: Jan 2004
Posts: 107
Likes: 0
From: Houston TX
Car: 91 firebird TBI
Engine: Three SLow Five. LO3
Transmission: MAN 5 SPD B0RG WARNER, 77MM, 2.95
HAHA noway i wish i was loaded. hopefully i get this job at auto zone, and also i plan to use what left over financial aid i have from payin for college.
Why do you say its a waste of money, i was thinkin the same thing. might as well just buy the crate 350 HO from jegs. its only $2299.99. could i use my current tranny or should i opt for a new or salvaged one. i need suggestions or something, i need more power. i hate mustangs.
Why do you say its a waste of money, i was thinkin the same thing. might as well just buy the crate 350 HO from jegs. its only $2299.99. could i use my current tranny or should i opt for a new or salvaged one. i need suggestions or something, i need more power. i hate mustangs.
Joined: Feb 2001
Posts: 13,758
Likes: 560
From: Cincinnati, OH
Car: '90 RS
Engine: 377 LSX
Transmission: Magnum T56
Originally posted by dopplereffect
i need more power. i hate mustangs.
i need more power. i hate mustangs.
Thread
Thread Starter
Forum
Replies
Last Post





