to the moderators
Thread Starter
Member
Joined: Jan 2001
Posts: 288
Likes: 0
From: west Point MS USA
to the moderators
Which one of you guys put in a 350 in a TBI car?And if you don't mind,what are the cost?I know what a 350 is cap. of doing,but where there any problems to doing this swap?Any minor differences that we need to know?Also why don't we have a tech article for this so we can show those TPI guys a thing or two? Don't want to sound like a smart butt,that is not my intent.
Senior Member
Joined: Oct 1999
Posts: 6,621
Likes: 2
Car: 91 Red Sled
Axle/Gears: 10bolt Richmond 3.73 Torsen
That would be me. There are a few other guys, I know scauffiel, z28 boy, and rsilver all have 350+ TBI setups. I'm working on a tech article but I've been busy with work and the such. I'm slowely going through everything but expect it soon.
There is almost nothing special about swapping in a 350 for a 305. You need a new 350 knock sensor and it's a good idea to get a custom chip. Other than that it's pull, prep, and install.
------------------
, Jon (350 TBI!)
91 Red My website
There is almost nothing special about swapping in a 350 for a 305. You need a new 350 knock sensor and it's a good idea to get a custom chip. Other than that it's pull, prep, and install.
------------------
, Jon (350 TBI!)
91 Red My website
Thread
Thread Starter
Forum
Replies
Last Post