ok i put the crane compucam 2031 in my bird (big improvement over stock) and on the spec card it says an adjustable fuel pressure regulator is required for the cam. well i printed out the directions from the tech article on how to adjust the fuel pressure regulator on the tbi, but the question is should it be more or less pressure, anyone have an idea on what the pressure should be? thanx in advance for any help
--Stormr

------------------
"If its in my way-It gets run over"

--'91 firebird
305 TBI
Hypertech chip-thermomaster
Edelbrock performer intake
Crane compucam 2031
B&M shift kit
straight pipe exhaust-with Flowtech resonator tips
160 thermostat
open element

 

12 psi is a good start, maybe a little lower. Thats what my brother is running on a 310 with INtake cam and Vortec heads so I would saay atrt at near 11 or 12 and see how that works.

------------------
89 Trans Am Turbo 3.8L All stock 43,000 miles #1053 of 1555

Past Thirdgen:
86 Trans Am w/ built 355TPI with SLP goodies and too much other stuff to List. One sweet *** car, wish I would have had a good enough Job to pay insurance on three cars so I could keep it, but for a 89 Turbo Trans Am w/ Low miles, I think I made the right choice!