Cam install and degreeing?
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jun 2001
Posts: 1,668
Likes: 0
From: Dale City, VA
Car: 91 GTA and 85 IROC
Engine: 355
Transmission: gear jammer
Axle/Gears: 4.11
Cam install and degreeing?
I would like to degree my cam I just bought. How hard is it? I'm a little worried about screwing things up and costing myself serious HP. Comp cams just tells you to buy their video. Will I be ok w/o degreeing it, or should I buy the kit w/ the video and spend the extra time and money? Thanks in advance.
:hail: :hail: :hail:
:hail: :hail: :hail:
Last edited by Free Bird; Oct 15, 2002 at 10:23 PM.
Supreme Member
Joined: Nov 2000
Posts: 1,078
Likes: 0
From: San Antonio, TX
Car: Damn
Engine: This
Transmission: New Stuff
Comp grinds 4* advanve into their cams, so when you go straight up you have that advance already there. by degreeing the cam, you can verify Comp's 4* advance, or set it retarted or advance to your specs.
TGO Supporter
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
look in a comp or lunati catalog, or their sites and it'll explaine everything to you ,with pics too. it's not hard to degree a cam and is good insurance against someone messing up when it was ground.
Moderator
Joined: Jan 2000
Posts: 19,640
Likes: 306
Here's another good source: http://www.cranecams.com/instruction...ing/degree.htm
Thread
Thread Starter
Forum
Replies
Last Post
Fronzizzle
Suspension and Chassis
6
Mar 18, 2019 08:29 PM
