how hard is it to find a roller 350 block in junk yards? they should be in 87 and newer vehicles right? are all of the 87 and newer blocks roller?

also, if i have a flat tappet cam with 204int 214exh duration at .050 and .422/.444 lift how much more hp should i see from going to a roller cam with a just little more duration and lift.

 

not hard, it'd be harder to find a non roller, i little more HP with a little more lift and duration

 

Well, I'm selling a short block out of an 89 Formula. It is a roller 350 w/ about 72,000 miles on it. The car was rear ended. If you are interested in something out of state, let me know. I am in Phoenix AZ. Asking $150. If interested, call 623-572-9769....Joe

 

i would be interested but i'm only 16 and i don't have the money right now. i'm also in VA and my parents wouldn't want to have an engine shipped from AZ. right now i'm just trying to figure out what i want to do.

 

where at in VA are you?

 

fredericksburg, about 60 miles south of DC.