i need help quick if possible!!!!
i need help quick if possible!!!!
i was taking my manifolds off today and i accidently broke the thing that the heater hoses go into.. i dotn know the name of it i just know that three hoses go into it and a vacum hose goes to it also it is round at the top and has a cylinder at teh bottom. i just knwo it turns the heater on and off i think. where can i get one of these and how much are they i hope they are not that much.. also one of the hoses look like they either go into the tb or under it.. thanks for your help..
------------------
1988 firebird ws6 formula350tpi msd 6al box blaster 3 coil accel 8.8 wires flowmaster cat back pro shift light a pillar gauge pod and water temp and air/fuel ratio gauges b&m mega console shifter, march underdrive pullies, tpis airfoil
best 1/4 mile run of 14.44@ 96.53
------------------
1988 firebird ws6 formula350tpi msd 6al box blaster 3 coil accel 8.8 wires flowmaster cat back pro shift light a pillar gauge pod and water temp and air/fuel ratio gauges b&m mega console shifter, march underdrive pullies, tpis airfoil
best 1/4 mile run of 14.44@ 96.53
Supreme Member
Joined: Aug 1999
Posts: 1,053
Likes: 3
From: San Diego, CA
Car: 87 Buick GN
Engine: 3.8L (231 cid) V6
Transmission: 200-4R
Axle/Gears: 10 bolt G80/ 3.42
Heater control valve...any auto parts store should carry them.
Don't remember how much they cost but it's really cheap. Around 10-12 bucks I think. HTHs.
------------------
1989 IROC-Z, ZZ3 shortblock with some bolt-ons.
13.20 @ 108.69, 2.2 60'
Don't remember how much they cost but it's really cheap. Around 10-12 bucks I think. HTHs.
------------------
1989 IROC-Z, ZZ3 shortblock with some bolt-ons.
13.20 @ 108.69, 2.2 60'
Thread
Thread Starter
Forum
Replies
Last Post
3.8TransAM
NW Indiana and South Chicago Suburb
1
Sep 27, 2015 08:37 PM




