Fuel pressure shrad valve help!
Thread Starter
Moderator
Joined: Jul 2001
Posts: 5,225
Likes: 70
From: Buffalo, NY
Car: 1988 IROC-Z
Engine: 427 SBC
Transmission: ProBuilt 700R4
Axle/Gears: Moser 12 Bolt / 3.73 TrueTrac
Fuel pressure shrad valve help!
I am having some trouble getting my gage on the rail! Is this the right fitting?
Or do I need this?
I can get it to get snugg, but thats it. I could easily pull it off.
Or do I need this?
I can get it to get snugg, but thats it. I could easily pull it off.
Last edited by IROCThe5.7L; Dec 28, 2003 at 03:26 PM.
TGO Supporter
Joined: Sep 2003
Posts: 6,127
Likes: 11
From: conway, s.c.
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
The tester that you are showing is for the TBI fuel rails. The pressure guage should screw down on the schader valve, not be pressed down on it.
The Trickster!!!!!!!!!!!!!!!
The Trickster!!!!!!!!!!!!!!!
Thread
Thread Starter
Forum
Replies
Last Post
backtothe80s
Suspension and Chassis
33
Sep 5, 2015 12:39 AM
R3500
Engine/Drivetrain/Suspension Wanted
1
Aug 17, 2015 12:16 PM
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
