Since it looks like neither proform nor harland sharp makes them... who makes the cheapest full roller self aligning rockers ? I think my stock heads need self aligning rockers since there aren't any guide plates installed.

------------------
92 Z28 5.7
------------------
Ported stock heads, XR270HR-10 cam, TES headers
Crane AFPR, Flowmaster catback, MSD ignition
#24 SVO injectors, 1LE aluminum driveshaft.

Best ET 13.3@107 mph

Click here to see my car at Truspeed.org
Check out Truspeed
Check out the Bin Archive

 

not sure about cheap but crane makes self aligning in their gold series.

 

Yeah I know... but I dont feel like paying 300+ dollars to get 10 HP.. if that.

 

GM 1.5's and 1.6's are about $269 and are the GOld ones with GM name. I'd use the Comp Magnum's but they are not roller fulcrum'd, just roller tipped SA rockers and are bout $199?

 

i have a set of comp 1318 rockers, little over 300 dollars. i don't think you'll find and discount prices SA rockers.

------------------
ICON Motorsports

1st & 3rd

 

My car has the Comp Cams 1.52 roller rockers, they were $200 from Jegs.

------------------
1987 Chevy Camaro IROC-Z
L98 TPI 350 (5.7L)
TH 700R-4 Transmission
Borg Warner 7.75" 9 Bolt Rear End

Current Mods: LT4 Hot Cam, Comp Cams 1.52:1 Roller Rocker Arms, Edelbrock TES 1 5/8" Headers, Hooker 3" Aerochamber Cat-Back System, Performance Resource Chip, Accel Ignition Coil, Cap, Rotor, 8.8mm Wires, K&N Filters, JET TPI Air Foil, All Free Mods, Falken ZIEX Z-Rated Tires.

Best ET (w/o LT4 cam): 14.32 @ 97.7mph
(corrected for elevation)

7.5" 10 Bolt with 3.42s soon to come!

 

dan are they SA? i didn't think comp had SA rockers untill a few months ago? i ordered mine in november and it took untill late december for them to be avaiable. pn 1318 SA 1.6

------------------
ICON Motorsports

1st & 3rd

 

Dan/Ede, they are ROLLER-TIPPED rocker arms!!! They are NOT FULL roller rockers!!!

I'd buy SA FULL rollers from COMP for $200 in a heartbeat but they do not exist for that price, unfortunately.

[This message has been edited by FastBroker (edited February 17, 2001).]