Hooking up the EGR Solenoid?
Thread Starter
Senior Member
Joined: Dec 2003
Posts: 758
Likes: 1
From: Ontario, Canada
Car: 1988 Pontiac Trans Am
Engine: 5.0L Fuel Injection
Transmission: Automatic 4speed /w OVerdrive
Hooking up the EGR Solenoid?
Anyone have any advice on what steps I should take to hook up this EGR solenoid.
Also does it matter which hose goes where? is this thing flow dependant or will it accept reverse flow?
Also does it matter which hose goes where? is this thing flow dependant or will it accept reverse flow?
Thread Starter
Senior Member
Joined: Dec 2003
Posts: 758
Likes: 1
From: Ontario, Canada
Car: 1988 Pontiac Trans Am
Engine: 5.0L Fuel Injection
Transmission: Automatic 4speed /w OVerdrive
Well I found the directions in the haynes manual however I am not sure if this solenoid is omnidirectional. Basically I took a pic of the solenoid...maybe someone out there can give me a quick shout out on which way it goes.
Basically, does gold go to the valve or to the Throttlebody?
Basically, does gold go to the valve or to the Throttlebody?
Supreme Member
iTrader: (2)
Joined: Jul 2003
Posts: 3,205
Likes: 0
From: Dallas, TX area
Car: 91 Formula WS6 (Black, T-Tops)
Engine: 383 MiniRam (529 HP, 519 TQ - DD2K)
Transmission: Built '97 T56, Pro 5.0, CF-DF
Axle/Gears: 4.11 posi Ford 9"
The metal spout gets connected to the bottom of the throttle body and the plastic spout goes to the EGR valve.
Thread
Thread Starter
Forum
Replies
Last Post
