I am looking for tools j-35118-2 and J-35118-5. I called up Kent Moore tools, the first tool dealer I could find that had GM tool numbers listed since dealers wont sell tools, they had 4 of the 6 tools I needed, but these 2 were discontinued. I was wondering if any GM techs out there knew if there were updated tool numbers, or if its just that, discontinued, and I'll have to use a "universal" jig, or the old take the rear apart, add/subtract a shim, reassemble, etc. I realize I will still have to do this somewhat, but I figured the tools would help me get a lot closer to exact, a lot faster.

If you have any info, please post
Thanks
Corry

 

what do they do, or what are they for? very good chace you'll find it from snap on, mac, matco, kd, or lisle.

 

J-35118-2 is a guage plate
J-35118-5 is a spacer

Both are mentioned in the service manual for setting up the final drive.

EDIT: I did a search on all mentioned tool providers and found nothing. Still looking for more ideas.

 

you mean setting up the rear end or setting the alignment for the rear?