What is this?
Thread Starter
Member
Joined: Nov 2004
Posts: 110
Likes: 0
From: Orange Park, FL
Car: 1984 T/A
Engine: L69
Transmission: 700R4
What is this?
Piece that runs along the drive shaft that bolts to the tranny and then the rear axle??? I'm pulling the motor for a new one and was wondering if this thing was really needed when its time to put the new motor in?
Supreme Member
Joined: Feb 2004
Posts: 1,231
Likes: 1
From: Greenville, SC
Car: 1991 Chevy Camaro
Engine: 305 TBI
Transmission: 700R4
Axle/Gears: 3.42
That's the torque arm, and yes, you need to keep it installed. It's what keeps the whole rear axle assembly from moving vertically under acceleration/deceleration.
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
Re: What is this?
Originally posted by 84taowner
Piece that runs along the drive shaft that bolts to the tranny and then the rear axle??? I'm pulling the motor for a new one and was wondering if this thing was really needed when its time to put the new motor in?
Piece that runs along the drive shaft that bolts to the tranny and then the rear axle??? I'm pulling the motor for a new one and was wondering if this thing was really needed when its time to put the new motor in?
Thread Starter
Member
Joined: Nov 2004
Posts: 110
Likes: 0
From: Orange Park, FL
Car: 1984 T/A
Engine: L69
Transmission: 700R4
Re: Re: What is this?
Originally posted by dimented24x7
Without it, there wont be anything to provide the counter torque to keep the rear in one spot. The rear would try to spin around under power and probably rip the suspention apart and damage the D/S without it.
Without it, there wont be anything to provide the counter torque to keep the rear in one spot. The rear would try to spin around under power and probably rip the suspention apart and damage the D/S without it.
