View Poll Results: What is the best set-up for my engine combo
Edelbrock High-Flo Intake and Runners
0
0%
TPIS Mini-Ram
4
80.00%
Holley Stealth Ram
1
20.00%
Voters: 5. You may not vote on this poll
TPI Systems
Thread Starter
Senior Member
iTrader: (1)
Joined: Sep 2004
Posts: 546
Likes: 0
From: Columbia, Missouri
Car: '87 Iroc-Z
Engine: 355cid Cam'd
Transmission: T5 Manual
Axle/Gears: Stock 9 Bolt
TPI Systems
What intake set-up would you recommend for a 383 Stroker L98 with the following mods:
Edelbrock E-tec 200 heads
Edelbrock Performer RPM Cam
Crane High-Intensity Roller Lifters
Stud Girdle
Forged bottom-end
125 hp shot of nos
3.73 rear ends
Trans-Go Shiftkit
Ported Plenum
I want peak horsepower between 5500 and 6500 rpm. I'm also wanting to race my car in SCCA and NASA Camaro Mustang Challenge. Yet I want to get decent gas mileage for my semi-daily driver.
Edelbrock E-tec 200 heads
Edelbrock Performer RPM Cam
Crane High-Intensity Roller Lifters
Stud Girdle
Forged bottom-end
125 hp shot of nos
3.73 rear ends
Trans-Go Shiftkit
Ported Plenum
I want peak horsepower between 5500 and 6500 rpm. I'm also wanting to race my car in SCCA and NASA Camaro Mustang Challenge. Yet I want to get decent gas mileage for my semi-daily driver.
Thread
Thread Starter
Forum
Replies
Last Post
beachrodder
Tech / General Engine
7
Aug 25, 2015 08:05 AM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM
