only 10psi of oil pressure on the stand when primingg
Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 1,443
Likes: 0
From: College Station, Tex USA
Car: 89rs
Engine: 400Sb
Transmission: Tremec 3550
only 10psi of oil pressure on the stand when primingg
All the rockers have oil. But, the drill just kind of spins free with not much load. I only gave about 10mins before stopping. I am going to go spin it some more later. Thread Starter
Supreme Member
Joined: Aug 1999
Posts: 1,443
Likes: 0
From: College Station, Tex USA
Car: 89rs
Engine: 400Sb
Transmission: Tremec 3550
one of those hate to admit things.. always make sure you check the oil pump bolt torque. I had started messing with the windage tray and did not go back to the pump to finish. got 60+ psi now.
Senior Member
Joined: Dec 2000
Posts: 516
Likes: 0
From: Mission Viejo, CA
I know this sounds stupid but you are turning it the right way right? It's suppose to turn clockwise. othere then that the only thing I can think of is a bad pump or there is a big leak inbetwwen the oil pump and the block.
Thread
Thread Starter
Forum
Replies
Last Post