Rocker Stud Torque
Thread Starter
Member
iTrader: (2)
Joined: Jun 2001
Posts: 432
Likes: 17
From: Dover, De U.S.
Car: 1991 Z-28/ '94 Impala SS
Engine: 355 TPI/ 350 LT-1
Transmission: T-56 in both
Axle/Gears: 3.73 / 4.56
Rocker Stud Torque
This is somewhat of a Vette question, but they are going on a TPI 91 Z. Looking for a good torque spec for a 7/16 in rocker stud in a vette L98 alloy head? Anyone. Thanks
Mike
Mike
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
You might want to verify that before applying the torque.
RB might be right, but where I work (not automotive), the same fastener going into Al vs. Fe does make a difference.
RB might be right, but where I work (not automotive), the same fastener going into Al vs. Fe does make a difference.
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Peace. World says 55 ft-lbs for their iron heads.
Once again, RB hits the nail on the head.
Once again, RB hits the nail on the head.
Thread
Thread Starter
Forum
Replies
Last Post
