Hey! I've pretty much got everything ready to go on the Pro-Ram I just installed except the O2 sensor. Accel did not send me one so I've had to splice my old heated one into the harness. The problem is I don't know which wires go where. There is a black one, a red one, and a red one with a white stipe. The reds are on the outsides of the connector. If someone could please tell me atleast the sequence of the wires on the connector it could really help. Like whether the sensor wire is in the middle or on one of the sides. Thanks!!!

I'm drooling over the fact of being able to drive my car!!

------------------
88 firebird formula
350 Vortec, Accel Pro-Ram MPFI
214int/224exh, .471int/.491exh
Edelbrock headers
T56 - SIX-speed
open 3.73's
3 inch Flowmaster catback
I love pissing those LS1's off

Old time with TBI - 13.9 @103mph, 2.6 60ft

My Formula

[This message has been edited by Birmass (edited October 27, 2001).]