14014415 Heads - Any good???
Thread Starter
Member
Joined: Jul 2004
Posts: 121
Likes: 0
From: Midland, MI
Car: 1983 Z28, 2001 Dodge 2500
Engine: 355 carb, V-10 8.0L
Transmission: TH-350, 47re
Axle/Gears: 10 bolt w/ 2.93's
14014415 Heads - Any good???
Mortec says 80-85 267/305. I can get these for $300 - $400. I would look to put these on a 1989 350 short block with dish pistons. Looking for a 58cc - 64cc head to help keep the CR up.
CASTING # 14014415
58cc
NEW 2.02INT. 1.6 EX. STAINLESS VALVES
550 LIFT SPRINGS
MAGNAFLUXED FOR CRACKS
RESUFACED ON BLOCK AND INTAKE SIDES
3/8 SCREW-IN STUDS
GUIDE PLATES
POCKET PORTED WITH BOWL HOG
STEAM HOLES FOR 400 SBC
ALL WORK WAS DONE BY ASE MACHINE SHOP
How about the same specs as above but with 601 casting number?
How would these compare to a set of 416 casting 305 heads reworked with 1.94" intake / 1.60" exhaust and port work?
CASTING # 14014415
58cc
NEW 2.02INT. 1.6 EX. STAINLESS VALVES
550 LIFT SPRINGS
MAGNAFLUXED FOR CRACKS
RESUFACED ON BLOCK AND INTAKE SIDES
3/8 SCREW-IN STUDS
GUIDE PLATES
POCKET PORTED WITH BOWL HOG
STEAM HOLES FOR 400 SBC
ALL WORK WAS DONE BY ASE MACHINE SHOP
How about the same specs as above but with 601 casting number?
How would these compare to a set of 416 casting 305 heads reworked with 1.94" intake / 1.60" exhaust and port work?
Last edited by bigblockcamaro; Oct 3, 2005 at 05:41 PM.
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Out of curiosity, what would they charge for similarly prepped 601 or 416's?
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
Aug 23, 2015 11:49 AM
