Put hole in heater box!
Thread Starter
Senior Member
Joined: Oct 2003
Posts: 942
Likes: 0
From: LaGrange (10min from Poughkeepsie), NY
Car: 1992 Camaro RS - not real slow anymore...
Engine: SPDC 360 MAF EFI /w a Holley Stealth Ram
Transmission: T5 untill it blows up from to much torque
Axle/Gears: Ford 9" /w auburn pro & 3.89's
Put hole in heater box!
When I was dropping in the 350ci, The valve cover put a nasty hole in that thin plastic heater core box. It measures about 1.5" by 1.5". Any recommendations on how to fix this? JB Weld? -I have the origional plastic that was broken off, it's in 1 piece still surprizingly.
Joined: Jul 1999
Posts: 1,992
Likes: 10
From: CT
Car: 1986 Camaro SC
Engine: 305 TPI Procharged D1SC
Transmission: Tremec TKO-600
Axle/Gears: Moser 12 Bolt 3.73 posi
i had a small hole in mine, the top is plastic the bottom is fiberglass, i just fiberglassed over the hole
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
