cant
Thread Starter
Member
Joined: Jan 2006
Posts: 128
Likes: 0
From: iowa
Car: 2001 ram (prev 84 and 93 ta)
Engine: 360 (cold air, exhaust)
Transmission: plastic stock dodge....
Axle/Gears: ...havent looked that far....
cant
i cant keep my car running at idol
the carbs stock and everything
i changed the pluggs yesterday cause i have new wires on it.. and for some odd reason it doesnt want to idol any more... whats the reason for this, i believe all the wires are on correct because the drivers side i did, and i did most the passanger side.. im going to flip some wires around.. and find out why its doing this.. however is there anythig else i need to know about?
the carbs stock and everything
i changed the pluggs yesterday cause i have new wires on it.. and for some odd reason it doesnt want to idol any more... whats the reason for this, i believe all the wires are on correct because the drivers side i did, and i did most the passanger side.. im going to flip some wires around.. and find out why its doing this.. however is there anythig else i need to know about?
Supreme Member
iTrader: (3)
Joined: Sep 2005
Posts: 1,685
Likes: 3
From: MD
Car: '88 IROC-Z medium orange metallic
Engine: L98
Transmission: 700R4
Axle/Gears: 3.27
Check the choke to make sure it's operating properly. Check for vacuum leaks. Check to make sure the fuel pump is working.
Senior Member
Joined: Nov 2004
Posts: 560
Likes: 0
From: Currently:...Home: Texas City.
Car: 89 Formula 350 (x 2)
Engine: L98
Transmission: 700R4
Axle/Gears: BW 3.27
Don't go "flipping wires around". Just put them on correctly.
Check your manual, or do a
for firing order on this same board. You'll get your answer pretty quick, one of the mods posted a good diagram.
Check your manual, or do a
for firing order on this same board. You'll get your answer pretty quick, one of the mods posted a good diagram. Thread Starter
Member
Joined: Jan 2006
Posts: 128
Likes: 0
From: iowa
Car: 2001 ram (prev 84 and 93 ta)
Engine: 360 (cold air, exhaust)
Transmission: plastic stock dodge....
Axle/Gears: ...havent looked that far....
check
i checked my haynes manual on it.. the wires were correct.. everything correct.. i just put synthetic oil in it.. its runnin fine now.. i dont know if it just took a minute a few minutes to get the synthetic everywhere but what ever it is its fine...
