HEI distributor coil melting
Thread Starter
Member
Joined: Jul 2001
Posts: 401
Likes: 0
From: Surrey,BC,Canada
Car: 1989 Trans Am GTA
Engine: 5.7L 600cfm carb
Transmission: 700R4 (auto)
HEI distributor coil melting
lately my car has been running like total crap. i tryed to replace the coil in the distributor because the old one looked pretty melted and the metal bar going through the middle had like a 1/4 inch of play. also the red wire going into it was also kind of charred. the car ran much better for a few days, but now my car is running almost as bad as it was before and i have a bad feeling it melted the new coil. what on earth could cause this? my old coil was only a year old. i get some real bad bogging down upon acceleration from idle, and ive noticed when the car is fully warmed up (after sitting in a bit of traffic) the rpms become unstable and it almost stalls. any ideas?
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
The coil and ignition module are often a "chicken or egg" thing.
It's a good idea to replace both when either one has gone bad.
It's a good idea to replace both when either one has gone bad.
Thread
Thread Starter
Forum
Replies
Last Post
92rsvortec350
Engine/Drivetrain/Suspension Parts for Sale
19
Oct 9, 2015 09:39 AM
skinny z
Engine/Drivetrain/Suspension Parts for Sale
5
Oct 5, 2015 06:23 PM
Damon
Tech / General Engine
8
Sep 26, 2015 04:29 PM






